SoftServo-B10CH (Servo Controller/ RC Signal Generator) [Discontinued] _MAKE_SENSOR Arduino Leonardo or ATmega32u4 compatible

Arduino Leonardo or ATmega32u4 compatible - 12 analogue channels at 10-bit resolution

• Official Raspberry Pi Red & White Case

The Pi-EzConnect GPIO HAT lets you connect electronics to your Raspberry Pi using screw terminals

Width:19mm

# uncomment if you get no picture on HDMI for a default "safe" mode #hdmi_safe=1 # uncomment this if your display has a black border of unused pixels visible # and your display can output without overscan #disable_overscan=1 # uncomment the following to adjust overscan

SoftServo-B10CH (Servo Controller/ RC Signal Generator) [Discontinued] _MAKE_SENSOR Arduino Leonardo or ATmega32u4 compatibleStrictly speaking, SoftServo B10CH is a 10 channel PWM signals generator, which can be applied to most of the devices that integrate RC interface, but the original intention of the design is to control the PWM Style servo. It integrates RS485 and I2C into one connector, and they share the same user register, so the servo controller can be used via any one of the two interfaces at any time. All functions can be performed by reading or writing the user