M5Stack LAN Module W5500 with POE V1.2 _MAKE_DEV_CHALLENGER 0V) 2 + Power Input

0V) 2 + Power Input VCC (5

That's the best way to interface this display to just about any microcontroller (including Arduino & friends) If you want to control with from an HDMI or DVI output

old FiestaWare

and with SparkFun Qwiic compatible STEMMA QT connectors for the I2C bus

as shown in the table below

M5Stack LAN Module W5500 with POE V1.2 _MAKE_DEV_CHALLENGER 0V) 2 + Power InputThe M5Stack LAN PoE BASE V1. 2 is an Ethernet control module that integrates PoE (Power Over Ethernet) functionality. The module adopts a W5500 full hardware TCP IP embedded Ethernet controller (SPI communication interface) scheme, supports multiple communication protocols (TCP, UDP, IPv4, ICMP, ARP, IGMP and PPPoE, etc.) and network packet processing. Internally reserved expansion pads can be used to expand RS485 RS232 CAN communication adapter